Here >> List > Water Tank Series > Moderate Airtight Water Tank

• (State Construction Standard Design Collective drawings 98R109 has been changed to 98R401-1 from Mar.1,2002)
• 1. Be applied with normal temperature oxygen removing equipment to storage non-oxygen water,rubber plank between the floating cover and the wall can avoid air to contact with water,otherwise to make sure pressure is stabilization;
• 2. All the more,be used to reclaim condensation water 100℃ from water or steam heating perch expandation water tank;
• 3. Inner rubber canister is adhibited by polyurethane.The canister length is the heighth H of water tank and 100mm,the rubber plank dia. nearing the water tank is the dia. D of the water tank subtracting 15mm,the same to the floating cover’end is D-10 and the thickness of all felting layer is 40mm;
• 4. The crystal ball line upon line in the ring-trough ensuring rubber canister not be pushed outside by water;
• 5. Could solder continuously on place where need preventing water leak, finally,brush anticorrosive paint and gray paint on suface of inside and outside;
• 6. Only a take-over on the bottom of the water tank,set up a base of brick or RC under the tank when install model 5-8.
• 7. Close the manual exhaust valve on the side of tank after full.
• 8. Use many tanks as one by parallel connection,but only one display controller is need.

No.	Exterior Dia.(mm)	Height(m)	Capability(m3)	Weight(Kg)
1#	Æ800	1.15	0.35	150.5
2#	Æ1000	1.35	0.7	213.4
3#	Æ1200	1.55	1.24	283.8
4#	Æ1400	1.75	2.0	367.7
5#	Æ1600	1.95	3.0	523.3
6#	Æ1800	2.15	4.85	643.2
7#	Æ2000	2.35	5.9	947.4
8#	Æ2200	2.55	7.97	1142
9#	Æ2400	2.6	10.86	1463
10#	Æ2500	2.8	12.76	1816
11#	Æ2600	2.8	13.80	1962
12#	Æ2800	3.0	17.24	2200
13#	Æ3000	3.0	19.79	2383

Depending on our abundantly experience,we ameliorated the State Standard Drawings 98R109 for more accurate and stead-run of water tank.

Apprise us of the model、dimension and quantity.